• Home
  • HappyModel BNF Moblite7 V3 HDZERO 1S 75mm Whoop - Choose Your RX

HappyModel BNF Moblite7 V3 HDZERO 1S 75mm Whoop - Choose Your RX

251.99
        SPECIAL OFFER

          Please select all product options

          Product was out of stock

          share
          Description

          The Happymodel Moblite7 HDZero Whoop is a 75mm HD brushless whoop weighing just 29.5 grams. It features the HDZero Whoop Lite VTX and Nano Camera and a built-in SPI ELRS 2.4GHz or FrSky 2.4GHz receiver.  With powerful EX1002 KV20000 motors and a Superbee F4 Lite flight controller, this should be a great performing high-definition whoop you can fly just about anywhere.

          UART ELRS v3.0 ready

          Be sure to check out all our pre-built quads, and all our Happymodel products

          Features

          • The lightest 1S 75mm brushless whoop
          • Powerful and efficiency
          • The lightest 1S AIO 5IN1 F4 flight controller
          • 1002 brushless motors
          • Low-profile Canopy design
          • HD Zero

          Specifications

          • Wheelbase: 75mm
          • Size: 97x97x25mm
          • Weight: 19.5g (without battery)
          • Weight: 36g

          Motor

          • Model: EX EX1002 20000KV
          • Configuration: 9N12P
          • Stator Diameter: 10mm
          • Stator Length: 2mm
          • Shaft Diameter:Φ1.5mm
          • Motor Dimension(Dia.Len): Φ13.5mmx12.5mm
          • Weight(g): 2.5
          • No.of Cells(Lipo): 1S only

          Flight Controller

          • SPI ELRS version Firmware target: CrazybeeF4SX1280
          • SPI FRSKY version Firmware target: CrazybeeF4FR
          • MCU: STM32F411CEU6 (100MHz, 512K FLASH)
          • Sensor: ICM20689 or ICM42688P or BMI270(SPI connection)
          • Original whoop size compatible
          • Power supply: 1S battery input (DC 2.9V-4.35V)
          • Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
          • Built-in Betaflight OSD(SPI Control)
          • Built-in 5.8G VTX
          • Built-in SPI Frsky/ELRSreceiver
          • Built-in 5V 1A BEC
          • Built-in voltage detection

          Onboard 4in1 ESC

          • MCU Upgraded to EFM8BB21
          • Power Supply: 1S LiPo/LiPo HV
          • Current: 5A continuous, peak 6A (3 seconds)
          • Support BLHeliSuite programmable
          • Factory Firmware: O_H_50_REV16_8.HEX
          • Default Protocol: DSHOT600

          Onboard Frsky SPI D8 receiver Version

          • SPI BUS receiver Frsky D8/D16 compatible
          • Compatible Non EU transmitter D8 model and EU-LBT(Frsky_x_lbt)
          • Channels: 8ch or 16ch
          • Failsafe support
          • No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
          • Based on CC2500 RF module Compatible with Futaba S-FHSS , Redpine protocol

          Onboard ELRS Receiver Version

          • Packet Rate option: 25Hz/50Hz/150Hz/250Hz/500Hz
          • RF Frequency: 2.4GHz
          • Telemetry output Power: <12dBm
          • Receiver protocol:  SPI ExpressLRS
          • Could bind with ELRS V2.0 firmware TX module

          Onboard 5.8G 40CH 25-200mW VTX

          • Output Power: 25mw~200mw switchable
          • Frequency: 40CH
          • Input Voltage: 3.3V 5.5V
          • Current Consumption: 300mA (type)
          • Frequency: 5.8GHz 5bands 40 channels (include Race band)
          • Smart-audio Ready

          HDZERO NANO LITE CAMERA SPECIFICATIONS:

          • Dimensions: 14x16x11 mm
          • Weight: 1.5gram
          • Sensor: 0.5 inch, up to 10650 mV/Lux-sec ultra-high sensitive CMOS sensor
          • Excellent low light performance
          • FOV:
            4:3: D:130° H:108° v:84°
            16:9:D:122° H:108° V:65°

            Includes

            • 1 x HappyModel BNF Moblite7 HDZERO 1S 75MM Brushless HD Whoop
            • 1 x Moblite7 Spare Canopy
            • 1 x Gemfan 1610 propeller Set (4cw+4ccw)
            • 1 x Propeller disassemble tool
            • 1 x Screwdriver